![[ POTM WINNER ]](images/potm/potm1.png?m=1654280436)
Wow 800 quid , thats a bargain compared to what its going to be worth now, And in original spec as well. Dont blame you for locking it away.
What engine was in the GSI?
I realy did like my vectra, I'm not sure why Clarkson hated on them so much.
I used to know...
Shadow Demon
Learner Driver
Last Activity: 19-06-2022, 11:26 AM
Joined: 09-06-2022
Location: Wolverhampton
-
It does need the manifold cleaning as its rammed but thats not a job for today. Going to order a new MAP sensor for it. Egr valve is not that bad, just I light coating.
egr tube is rammed at the manifold end.
Life of a diesel owner
Have you still got that vector...Leave a comment:
-
Nice and coked up there. Might have to clean the egr looking at that!Leave a comment:
-
Yeah,, I had an astra with the z19dth. Loved that car. Gearbox failed and cost me 2k for a rebuild, but it went on to do another 100k. Was on 249k when I scrapped it and the engine was still strong.Leave a comment:
-
You did not come across as stupid, I put the car down as 2014 so what you said was correct.
I will report back once I know more but it looks like I left my borescope at work and there is no way I'm removing the bumper just to check for a module. Might have to put it off till next weekend. ...Leave a comment:
-
I do have to say the you guys are all very friendly and helpfull. Most forums I use for other stuff are full of a$$hats, but then we are all lads from the UK.Leave a comment:
-
The car was registered in December 2013 so its a 13 plate. The car is a 14my in the build data that's why I put it down as a 14 plate or people would be asking if it was a face-lift when offering advise.
I think the TPMS reg was for cars after nov 2014 or there abouts....Leave a comment:
-
Sorry, I did not see your message.
I have not purchased the module yet as I have only just got the car and the other work i needed to do took priority.
Cambelt
New pads and disks all round as it was like trying to stop an oil tanker.
Dreaded oil seal as it would...Leave a comment:
-
Bad that you got a pressure warning over a disconnect unless it was just some random signal that jumbled the transmission data from the sensor after the sensor ident was sent, it is unlikely but technically it could still happen. 433-434mhz is a busy part of the radio spectrum but the car should have...Leave a comment:
-
Did it come up as a pressure warning or as a TPMS fault/disconnect? Just out of interest.
I have seen reports of the valve stem type getting stuck onto the valve stem but regular attention would prevent that situation.
I have also seen the aftermarket type that fit into the...Leave a comment:
-
F#*£@ng....
Leave a comment:
-
@exclusiv , I know what you are saying but I do a fair amount of motorway driving and just hate not having the system there.Leave a comment:
-
Thanks guy. I will get some pics up the weekend, its way too dirty for photos right now
Leave a comment:
-
TPMS retrofit
Hi All
I`m looking at retrofitting TPMS to my 2014 Insignia, I am looking for a person or company that can do the VCI programing to the BCM and IPAC. I was wondering if any of you was in the know of a company in the West Midlands area ?. -
No activity results to display
Leave a comment: