Found this on another forum so might help all of us with EPB in our cars------Dave
1, Block Drive Wheels.
2, Turn Ignition To the Run Position/Engine must be OFF,
3, Place Gearstick/Park in Neutral,
4, Press and hold Brake Pedal--Keep pressed down through this process,
5,Press and HOLD down the EPB Switch for approx. 5 seconds,
6,Observe the Park Brake Lamp on the Cluster and when the Park Brake FLASHES then Immediately Press and Release the EPB Switch, The Parking Brake Tension is now Fully released.
7, Release the brake pedal----you can now carry out any work needed on the rear brakes.
How to Enable Without Scan Tool.
1, Block Drive Wheels,
2, Turn Ignition To The Run Position/Engine must be OFF,
3,Press and hold Brake Pedal,
4,Place Gearstick in Neutral/Park,
5,Momentarily Lift the EPB switch to Apply the EPB,
6,Momentarily Press Down the EPB to Release the EPB,
7,Repeat steps 5 and 6 to cycle the EPB ON then OFF an additional 4 Times,
8, The EPB Module will now be calibrated and correct tension will be applied to the Parking brake cables
9,Release the BRAKE Pedal and your done.
1, Block Drive Wheels.
2, Turn Ignition To the Run Position/Engine must be OFF,
3, Place Gearstick/Park in Neutral,
4, Press and hold Brake Pedal--Keep pressed down through this process,
5,Press and HOLD down the EPB Switch for approx. 5 seconds,
6,Observe the Park Brake Lamp on the Cluster and when the Park Brake FLASHES then Immediately Press and Release the EPB Switch, The Parking Brake Tension is now Fully released.
7, Release the brake pedal----you can now carry out any work needed on the rear brakes.
How to Enable Without Scan Tool.
1, Block Drive Wheels,
2, Turn Ignition To The Run Position/Engine must be OFF,
3,Press and hold Brake Pedal,
4,Place Gearstick in Neutral/Park,
5,Momentarily Lift the EPB switch to Apply the EPB,
6,Momentarily Press Down the EPB to Release the EPB,
7,Repeat steps 5 and 6 to cycle the EPB ON then OFF an additional 4 Times,
8, The EPB Module will now be calibrated and correct tension will be applied to the Parking brake cables
9,Release the BRAKE Pedal and your done.
Comment