Hi all,
I'm changing my driveshaft seals but the offside is a real pig.
On the attached picture I am assuming I need to remove the entire support bearing housing (bolts indicated by no. 21). Or do I need to remove the bolts indicated by no. 19 to slide the intermediate shaft out of the gearbox.
The reason I ask is that I have tried removing the whole bearing housing but it catches on what I think is the oil cooler and there is no clearance.
Surely the bearing is pressed into the housing so wont budge if I try the other bolts.
Am I missing something?
Car is 1.6CDTI (SRi Nav) with the B16DTH engine and M32 Gearbox.
I'm changing my driveshaft seals but the offside is a real pig.
On the attached picture I am assuming I need to remove the entire support bearing housing (bolts indicated by no. 21). Or do I need to remove the bolts indicated by no. 19 to slide the intermediate shaft out of the gearbox.
The reason I ask is that I have tried removing the whole bearing housing but it catches on what I think is the oil cooler and there is no clearance.
Surely the bearing is pressed into the housing so wont budge if I try the other bolts.
Am I missing something?
Car is 1.6CDTI (SRi Nav) with the B16DTH engine and M32 Gearbox.
Comment