Hi guy, been out today to try and fit my new bmc cda intake on the 2014 insignia 2.0cdti 140 Sri vx, silicon pipe work is too small 😔 it fits inside the air flow sensor housing and can't get it over, going to try a bit boiling water see if i can streach it but don't want to crack the housing.... Anyway, when I removed the air box there is a small line that goes into the air box, bottom right corner, what's it for and is it required? If I fit the intake there's no where for it to go with the pipework I have.
Any advice greatly appreciated 👍
Any advice greatly appreciated 👍
Comment